I have also noticed some error messages when i boot linux related to the network driver: ath10k_pci 0000:02:00.0: firmware: failed to load ath10k/pre-cal-pci-0000:02:00.0.bin (-2)įirmware_class: See for information about missing firmwareĪth10k_pci 0000:02:00.0: firmware: failed to load ath10k/cal-pci-0000:02:00.0.bin(-2)Īth10k_pci 0000:02:00.0: firmware: failed to load ath10/QCA9377/hw1.0/firmware-6. With channels switching, i have tried using 1 specific channel yet i found not ports with this solution either. Using Kali Linux, a powerful Linux desktop. ![]() The Kali Linux desktop will now be launched. Select the C:/Kali folder and then click the Open button to open it. By clicking this, you will be taken to the Open File dialog box. I have tried airmon-ng check kill but it didn't work, when i run airodump-ng, here's what i get: CH 12 ][ 19:23īSSID PWR Beacons #Data, #/s CH MB ENC CIPHER AUTH ESSID To open a file, first select the File menu at the top of the main menu, then click Open File at the bottom of the menu. When I tried to catch a handshake using the airodump-ng -c -bssid -w handshake wlan0 command, the program showed the message: fixed channel wlan0: -1 I can enter the -ig flag in airodump-ng, but, in this case, the airplay-ng comand won't work for me.(mac80211 station mode vif disabled for wlan0) To scan a specific channel use airodump-ng -c channel no -bssid mac. (mac80211 monitor mode vif enabled for wlan0 on wlan0mon) I have installed Kali Linux in VirtualBox and my wireless adapters supports. Phy0 wlan0 ath10k_pci Qualcomm Atheros QCA9377 802.11ac Wireless Network Adapter (rev 31) The card in monitor mode, they will interfere by changing channelsĪnd sometimes putting the interface back in managed mode ![]() Kill them using 'airmon-ng check kill' before putting Here's the airmon-ng output: airmon-ng start wlan0įound 3 processes that could cause trouble. ![]() Additionally, airodump-ng writes out a text. If you have a GPS receiver connected to the computer, airodump-ng is capable of logging the coordinates of the found access points. airodump-ng is used for packet capturing of raw 802.11 frames for the intent of using them with aircrack-ng. I have a Qualcomm Atheros QCA9377 adapter that's integrated in my laptop (Dell Inspiron 15) and i'm running Kali Linux 64 2019.1 airodump-ng - a wireless packet capture tool for aircrack-ng. From the airodump-ng documentation describing the 'BSSID' field: MAC address of the access point. When I run airodump-ng to scan Wi-Fis around me, I get no output, like there's nothing around me.
0 Comments
Leave a Reply. |